SCADA Connect does not launch

SCADA Connect does not launch

Issue: SCADA Connect fails to launch. The SCADA Connect application may briefly appear then disappear.
Reported versions: 6.33
Possible affected versions: 6.33, 6.34, 6.35

    • Related Articles

    • TopView OPC cannot connect as Service

      This article is useful if TopView connects to your OPC server when run interactively, but cannot connect to remote OPC Server(s) when you run TopView as a Service. Interactive applications (non-Service) run under the account of the logged in ...

    • Unable to connect to iFix: "Requested operation requires elevation" - error 0x800702e4

      Error 0x800702e4 is due to OPC's use of DCOM. The OPC Server is requiring a different elevation status than the one offered by the TopView Configurator upon launch. Even though TopView may be running under a user account that is part of the ...

    • TopView engine unable to connect to OPC UA server: SHA 1 Certificates are not trusted

      Issue The TopView engine was unable to connect to the OPC UA server due to certificate issues. When inspecting the logs, we could see similar error messages to those that would occasionally appear when testing connections. This issue may show as the ...

    • Getting started with TopView

      TopView is a sophisticated product with a lot of functionality. Here's some of the best resources as you start with TopView: TopView on www.exele.com TopView product overview video TopView 101: An introduction to new users document Getting started ...

    • Diagnosing and fixing Remote Viewer connection problems

      Remote Viewer connection issues are often due to one of the following: The Remote Viewer is not enabled in the Engine's configuration The Engine is stuck in Startup and not yet listening (v6.35 and earlier) The Engine is unable to listen on the ...